Installing A Hard Drive Backplane - Dell VTY3T Manual

Figure 43. Removing a backplane
Next step
Install a hard drive backplane.
Related links
Removing a drive blank
Removing the optical drive cage or tape drive
Removing a cabled drive
Removing the air shroud
Removing the front bezel

Installing a hard drive backplane

Installing a hard drive backplane
Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 If installed, remove the bezel.
4 Remove the air shroud.
Steps
1 Use the hooks at the base of the system as guides to align the hard drive backplane.
2 Lower the hard-drive backplane into the system till the release pin locks in place, securing the hard drive backplane to the system.
3 Connect the data, signal, and power cables to the backplane.
Figure 44. Installing a hard drive backplane
Safety instructions.
Before working inside your system.
Installing and removing system components
Installation and Service Manual 91