Installing A Drive Blank - Dell VTY3T Manual

Figure 23. Removing a drive blank
Next steps
1 Follow the procedure listed in
2 Install a drive or a drive blank.
3 If applicable, replace the front bezel.
Related links
Removing the front bezel

Installing a drive blank

Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisite
Follow the safety guidelines listed in
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
After working inside your system.
Safety instructions.
Installation and Service Manual
Installing and removing system components
71