Lite-Vision plus Remote Controller
Basic wiring diagram
NOTE
Terminals of A and B have no polarity.
To diverge from the indoor unit
Remote controller
(header)
Terminal block
for the remote
control wiring
Earth
Note
• It takes some time before the remote controller becomes operable when the power is turned on. This is not a
malfunction.
<When the power is turned on the remote controller>
It takes about 1 minute before the remote controller becomes operable.
Power on
• For the operation of switching the room temperature sensor and the settings of the test operation, refer to the
page 18.
Remote controller
(follower)
(Sold
separately)
Remote control wiring
(Locally procured)
2
0.5 mm
to 2.0 mm
Indoor unit
About 1
minute
" " flashes
To diverge from the header remote controller
Remote controller
(header)
2
.
Terminal block
for the remote
control wiring
" "
disappears
– 8 –
Installation Manual
Remote controller
(follower)
(Sold
separately)
Remote control wiring
(Locally procured)
0.5 mm
Indoor unit
Earth
Remote controller becomes
operable.
2
2
to 1.25 mm
.