Toshiba RB-RWS20-E Installation Manual page 23

Lite-Vision plus Remote Controller
Entering the model name and serial number
Enter the model name and serial number manually for the outdoor unit. Information data is loaded automatically
for the indoor units. Enter the model name and serial number manually after replacing the circuit board to the
service circuit board (unless entering information manually before replacement of the circuit board).
Product
Indoor unit
Outdoor unit
Service circuit board
<Flow chart of usual process>
The model name and serial number loaded from the unit
are displayed.
1. Manual entry is not needed.
2. Select "Indoor unit (Outdoor unit)" for the display mode
(factory default).
Entering the model name and serial number manually
Register service info.
1.Service contact tel No.
2.Outdoor model name
3.Outdoor unit serial No.
4.Indoor model name
5.Indoor unit serial No.
Return
Outdoor model name
1.Manual model name input
2.Model name selection
Outdoor model name
Return Fix
Information data is loaded automatically from the indoor unit and displayed.
Enter information manually on the remote controller.
Enter information manually on the remote controller.
Does the indoor unit / outdoor unit automatically load information data of model
name and serial number to the remote controller?
Yes
Set
Set
Model name and serial number display
1. Enter the model name and serial number of the unit
manually on the remote controller.
2. Select "Remote controller" for the display mode.
1
Push the [
"2. Outdoor model name" on the "Register
service info." screen, then push the
"
Set
Select "3. Outdoor unit serial No." to enter the
serial number of the outdoor unit.
Select "4. Indoor model name" to enter the
model name of the indoor unit.
Select "5. Indoor unit serial No." to enter the
serial number of the indoor unit.
2
Push the [
"1. Manual model name input" on the
"Outdoor model name" screen, then push
the "
Set
Select "1. Manual serial No. input" to enter the
serial number of the outdoor unit.
Select "1. Manual model name input" to enter
the model name of the indoor unit.
Select "1. Manual serial No. input" to enter the
serial number of the indoor unit.
– 22 –
Installation Manual
No
∧ ∨
] / [ ] button to select
Set" [ F2] button.
∧ ∨
] / [ ] button to select
Set" [ F2] button.