Model Assembly; Horizontal Stabilizer Installation; Vertical Stabilizer Installation - FMS FMS137 Instruction Manual

Model assembly

Horizontal stabilizer installation

1.Attach the horizontal stabilizer to the fuselage as shown.
2.Insert the included two screws (HKM 3.0*10) into the circular aluminum part. Do not lock the screws. And then put
the aluminum part into the slot shown in the figure.
3.Lock the horizontal stabilizer to fuselage by tightening the screws on the circular aluminum part.

Vertical stabilizer installation

1.Connect the rudder servo connectors to the servo extensions in fuselage. Note the corresponding wire color.
2.Attach the vertical stabilizer to the corresponding slot at the rear of the fuselage as shown, and then use three
included screws (HKM 3.0*10) to fix it from the both sides of fuselage.
HKM3 .0x 10mm
HKM3.0 x 10mm
4
E
N