6. CLEANING PROCEDURE
Before unscrewing the hose, make sure it is not under pressure anymore.
1.
Empty the tank to the maximum without adding water inside.
2.
Clean the tank (remove the drain ball to allow water to drain from the tank,
the full product
3.
Once the tank is clean, replace the ball.
4.
Disconnect the product hose and fill the tank with clean water.
5.
Activate the rotation of the screw to clean the pump.
6.
Place the cleaning ball in the product outlet (8) and replace the hose.
7.
Start the machine.
8.
When the ball comes out of the hose, stop the machine and repeat operations 6 and 7 until water comes
out of the hose clean.
The direct projection of water under pressure onto the control panel has to be stopped at the
risk of water infiltration. Proceed by simply cleaning with a humid sponge.
202203-577-ENG
hose).
never run water through
User manual - X-PRO D200
P19