Operating the appliance
en
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, while the drum
is turning or during the active oxygen
phase, and it is not possible to add
laundry during this time.
It is possible to add laundry during
■
the sensoFresh î programme.
The load display is not active during
■
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press the Ü button.
1.
Select another programme.
2.
Press the Ü button. The new
3.
programme starts from the
beginning.
When switching from
Note:
programmes that use active oxygen to
those that do not, the door will remain
locked for up to 25 minutes until there
is no longer any active oxygen in the
drum.
The Ï and î symbols will flash. If the
symbols are off, the door can be
opened.
40
Cancel the programme
For programmes at high temperatures:
Press the Ü button.
1.
To cool down laundry: Select
2.
Rinse ¬.
Press the Ü button.
3.
For programmes at low temperatures:
Press the Ü button.
1.
Select Spin 0 or Empty p.
2.
Press the Ü button.
3.
When cancelling programmes
Note:
that use active oxygen, the door will
remain locked for up to 25 minutes until
there is no longer any active oxygen in
the drum.
Switch the appliance on again if
necessary. The Ï and î symbols will
flash. If the symbols are off, the door
can be opened.
Programme end during rinse
hold
In the display panel, $ flashes, and the
preset spin speed and remaining
programme length are displayed for the
selected programme.
Continue the programme by:
Pressing the Ü button or
■
Changing the spin speed, or setting
■
the programme selector to Empty p
and then pressing the Ü button.
Programme end
- 0 - and Ï appear in the display panel.
The Ü button indicator lamp is off.