Table of Contents
Advertisement
Sensors
en
Changing the signal volume
Use the Finish in + or - button to
change the following settings at the
corresponding programme selector
positions:
2: The volume of the information
■
signals and/or
3: The volume of the button signals.
■
Exit setting mode or:
Selecting/deselecting the
appliance automatic switch-
off
With the programme selector in position
4, press the Finish in + or - button to
turn the automatic switch-off function on
or off.
Exit setting mode or:
Switching the drum-care
information signal on/off
depending on the model
With the programme selector in position
5, press the Finish in + or - button to
switch the ä Drum Clean î
information signal on or off.
Exiting setting mode
To exit and save the settings, press the
# button.
The appliance is switched off. The
selected settings will take effect the next
time the washing machine is switched
on.
42
0 = off,
1 = quiet,
2 = medium,
3 = loud,
4 = very loud
H
Sensors
A utomatic load sensing
S e n s o r s
Depending on the type of fabric and
load, the automatic load sensing
function optimally adjusts the water
consumption and programme duration
in each programme.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry evenly in the drum.
~ Page 37, ~ Page 48
AquaSensor
Depending on the program and model
During a rinse cycle, the Aqua sensor
checks the turbidity of the rinsing water
(turbidity is caused by dirt and
detergent residue). The duration and the
number of rinse cycles depend on the
turbidity of the water.
Advertisement
Table of Contents
