Table of Contents
Advertisement
en operation
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 28
Press
Start/Reload.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.9 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
¡ The programme is set.
→ "Setting a programme", Page 28
¡ The programme end time is set
and activated.
→ "Buttons", Page 22
Press
Start/Reload.
1.
The activated programme end time
is paused.
Press
Ready In until the display
2.
shows the required programme
end time.
Press
Start/Reload.
3.
The changed programme end time
is activated.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
Start/Reload.
1.
The appliance pauses.
30
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 21
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
Start/Reload.
5.
13.11 Cancelling the pro-
gramme
Press
Start/Reload.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 23
Remove the laundry.
3.
→ "Unloading the laundry",
Page 31
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→ "Buttons", Page 22
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
Set the Spin programme or a pro-
1.
gramme for draining the water.
→ "Programmes", Page 23
Press
Start/Reload.
2.
programme.
Advertisement
Table of Contents
