Vinotemp Element EL-BWC108-SS-L Owner's Manual page 9

ANCHORING TO THE WALL
1. On the back of the appliance, attach brackets in the same zones shown using adhesive straps. Mark and
drill pilot holes for the screws about 8mm into the appliance. Then use a screwdriver to tighten the screws
all the way into the appliance.
2. Position the appliance in the desired location. Locate wall studs behind the appliance and mark the
location where the bracket on the back of the appliance lines up with a stud. Move the appliance away
from the wall and position bracket on the mark. Mark and drill pilot holes into the center of the stud with a
3/32" drill bit. Attach a bracket to the stud with the long screws provided.
3. Move the appliance into its final position, taking care to line up the wall bracket close enough to the
bracket on the back of the appliance to strap them together. Thread a strap through the brackets as
shown in the illustration. Tighten the straps until snug. Do not over-tighten.
CAUTION: This product is not intended to be a substitute for proper supervision. Manufacturer assumes no
liability for improper installation or excessive loads placed on screws, brackets, or straps.
Straps should be periodically adjusted, tested, and replaced.
9