Care And Maintenance - Vinotemp Element EL-BWC108-SS-L Owner's Manual

CARE AND MAINTENANCE

CLEANING YOUR BEVERAGE COOLER
IMPORTANT: Always unplug the unit before cleaning or performing maintenance. Never use harsh cleansers or
scouring pads to clean any part of the unit.
•
Turn off the power, unplug the appliance, and remove all items including shelves.
•
Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart of water.
•
Wash the shelves with a mild detergent solution.
•
Wring excess water out of the sponge or cloth before cleaning control panels or any electrical parts.
•
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean
soft cloth.
DEFROSTING
•
The unit defrost automatically.
•
The evaporator behind the rear wall of the unit defrosts automatically. The condensate collects in the
drainage channel behind the rear wall of the unit, and flows through the drainage hole into the drip tray by
the compressor where it evaporates.
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of your appliance. If the
power is off for an extended period of time, proper steps should be taken to protect your contents.
INACTIVITY
If the unit will not be used for a period of less than three weeks, leave the cooler operating. If the period of inactivity
is several months, remove all items and turn the unit off. Clean and dry the interior thoroughly. Leave the door open
slightly to prevent any possible moisture build-up.
MOVING YOUR WINE COOLER
Before moving your wine cooler, first be sure to remove all items from the cooler.
•
Securely tape down any loose items, such as shelves, inside the unit.
•
Turn the adjustable leg up to the base to avoid damage.
•
Tape the door shut.
•
Ensure that the unit stays securely in the upright position during transportation. Protect the outside of the
appliance with a blanket or similar item.
ENERGY SAVING TIPS
• The unit should be located in the coolest area of the room away from heat sources or direct sunlight.
•
Ensure that the unit has proper allowances on all sides for proper ventilation. Never cover any air vents.
•
Only open the cooler door for as long as necessary. Frequent opening of the door will affect internal temperature.
13