Installing A Hard Drive Into A Rear Drive Bay; Replacing The Dvd Rom Drive; Replacing The Front Port Panel - Bosch DIVAR IP 6000 Series Installation Manual

40 en | Maintenance
10.6.3

Installing a hard drive into a rear drive bay

To install a hard drive into a hard drive bay:
1.
2.
3.
10.7

Replacing the DVD ROM drive

The unit includes a DVD-ROM which is pre-installed.
To replace the DVD-ROM drive:
1.
2.
3.
4.
5.
6.
7.
10.8

Replacing the front port panel

If you must install a new or replace a damaged front port panel, observe the following
instructions.
2016.08 | V2.1 | DOC
Push against the upper part of the hard drive handle.
Push the hard drive horizontally into the hard drive bay, orienting the hard drive so that
the release button is on the right.
Push the hard drive carrier into the bay until the handle retracts and the hard drive clicks
into the locked position.
1
1 DVD-ROM
Turn off the unit and if necessary, remove the unit from the rack.
Remove the chassis cover.
Unplug the drives power and data cables from the motherboard and/or backplane.
Locate the locking tab at the rear (on the left when viewed from front) of the DVD-ROM
drive. Push the tab toward the drive and push the drive unit out the front of the chassis.
Insert the new drive unit in the slot until the tab locks in place.
Reconnect the data and power cables.
Replace the chassis cover. replace the unit in the rack, if necessary, then turn on the
system.
2
Installation Manual
DIVAR IP 6000 (3U)
2
Front port panel
Bosch Sicherheitssysteme GmbH