Installing A Hard Drive Into A Rear Hard Drive Carrier - Bosch DIVAR IP 6000 Series Installation Manual

DIVAR IP 6000 (3U)
To remove a hard drive from the chassis:
1.
2.
Notice!
Except for short periods of time (swapping hard drives), do not operate the unit with the
hard drives removed from the bays.
10.6.2

Installing a hard drive into a rear hard drive carrier

The hard drives are mounted in hard drive carriers.
To install a hard drive into the rear hard drive carrier:
1.
2.
3.
4.
5.
Notice!
We recommend using the respective Bosch hard disk drives. The hard disk drives as one of
the critical component are carefully selected by Bosch based on available failure rates. HDD –
not delivered from Bosch – are not supported. Information on supported HDDs can be found
in the datasheet in the Bosch Online Product Catalog.
Bosch Sicherheitssysteme GmbH
Press the release button to the right of the hard drive carrier. This extends the hard drive
carrier handle.
Use the handle to pull the drive out of the chassis.
Remove the screws securing the dummy drive to the hard drive carrier.
Remove the dummy drive from the hard drive carrier.
Insert a hard drive into the hard drive carrier with the printed circuit board side facing
down and the connector end toward the rear of the carrier.
Align the mounting holes in both, the hard drive carrier and the hard drive.
Note: There are mounting holes in the hard drive carrier marked "SAS" or "SATA" to aid in
correct installation.
Secure the hard drive to the hard drive carrier with four screws. Use the four M3 flat-head
screws included in the hard disk bag of your accessory box.
Note: To secure the hard drive, you cannot reuse the screws that are used to secure the
dummy drive to the tray.
Installation Manual
Maintenance | en 39
2016.08 | V2.1 | DOC