Removing The Monitor Pedestal Base - HP Compaq LA22f User Manual

Removing the Monitor Pedestal Base

You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture.
CAUTION:
power and signal cables are both disconnected. Also disconnect all USB cables connected to the
monitor.
1. Disconnect and remove the signal, power, and USB cables from the monitor.
2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3. Pivot the base 45 degrees clockwise and remove the screw from the back of the monitor, then pivot
the base 45 degrees counter-clockwise and remove the other screw from the back of the monitor.
Figure 3-9
4. Rotate the base of the monitor up (1) then pull it back (2) to unhinge the tabs on the monitor stand
from the slots in the monitor.
Figure 3-10
12 Chapter 3 Setting Up the Monitor
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Removing the Pedestal Base Screws
Removing the Pedestal Base
ENWW