Using The Auto-Adjustment Function - HP Compaq LA22f User Manual

Using the Auto-Adjustment Function

You can optimize the screen performance for the VGA (analog) input by using the
the monitor and the auto-adjustment pattern software utility on the CD provided.
Do not use this procedure if the monitor is using a DVI or DisplayPort input. If the monitor is using a
VGA (analog) input, this procedure can correct the following image quality conditions:
●
Fuzzy or unclear focus
●
Ghosting, streaking or shadowing effects
●
Faint vertical bars
● Thin, horizontal scrolling lines
●
An off-center picture
To use the auto-adjustment feature:
1. Allow the monitor to warm up for 20 minutes before adjusting.
2. Press the
●
You can also press the
the OSD Main Menu. Refer to
●
If the result is not satisfactory, continue with the procedure.
3. Insert the CD in the disc drive. The CD menu is displayed.
4. Select Open Auto-Adjustment Software. The setup test pattern is displayed.
5. Press the
6. Press the
ENWW
OK/auto button on the monitor front panel.
Menu
OK/auto button on the monitor front panel to produce a stable, centered image.
ESC key or any other key on the keyboard to exit the test pattern.
button, then select Image Control > Auto-Adjustment from
Adjusting the Monitor Settings on page 19
OK/auto
in this chapter.
Using the Auto-Adjustment Function
button on
17