Using The Accessory Rails; Removing The Monitor Pedestal Base - HP LP1965 User Manual

Using the Accessory Rails

The monitor features accessory rails on the rear that may be used to mount optional devices, such as
the HP speaker bar, to attach to the LCD. Refer to the documentation included with the optional device
for detailed mounting instructions.
Figure 3-13

Removing the Monitor Pedestal Base

You can remove the monitor panel from the pedestal base to mount the panel on a wall, a swing arm,
or other mounting fixture.
This monitor has a Quick Release mechanism that allows you to easily remove and replace the monitor
panel to the pedestal base.
CAUTION:
power and signal cables are both disconnected. If the monitor has a connected audio cable, disconnect
it.
1. Disconnect and remove the signal and power cables from the back of the monitor.
2. Slide the quick release latch (1) on the pedestal base to the side (either right or left).
ENWW
Using the Accessory Rails Feature
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Using the Accessory Rails 13