Table of Contents
Advertisement
Before you begin: This fireplace insert is supplied with a set of
five ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation from ceramic
fibers. After handling logs, wash your hands gently with soap and
water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation
of this fireplace. Sooting and other problems may result if the
logs are not properly and firmly positioned in the fireplace.
Refer to Figure 26 and 27 and corresponding WARNING when
completing following log placement steps.
1.
Remove the barrier screen. Press in and up at the top
of the barrier frame. Lift the barrier screen assembly up
approximately 3/8 inch until the bottom bracket is free from
the bottom of the glass door frame. Swing the bottom of the
barrier toward you until the barrier can be removed from the
top opening, which is the space between the surround and
insert top.
2.
Release two glass frame spring clamps at bottom of the
glass door assembly.
3.
Swing the bottom of the glass door outward approximately
10-15 degrees, then grasping the edges, gently lift upward to
remove the door assembly, and set aside.
4.
Remove the foam packaging that contains the log set from
inside the firebox.
5.
Carefully unpack the logs. Spread them out for easy
identification.
NOTICE: Continue to pages 26 - 31 for step by step
instructions with images.
E
B
Failure to position the parts in accordance with this diagram
or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
41380-0-0120
LOG PLACEMENT
D
A
C
Figure 26
WARNING
Figure 27
Decorative Rock is not included with the Fireplace Insert,
however it may be purchased separately and placed only
on the firebox floor. Do Not place decorative rock or rock
wool on the logs or burner assembly.
CAUTION
Page 25
Advertisement
Table of Contents
Troubleshooting
