Yamaha TT-R110EA Owner's Manual page 72

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2 3
1. Axle nut
2. Washer
3. Drive chain puller
4. Drive chain slack adjusting nut
5. Locknut
4. Loosen the axle nut.
5. Lift the rear wheel off the ground
according to the procedure on
7
page 7-28.
6. Remove the axle nut, washer and
the drive chain puller at the left-
hand side, then pull the wheel axle
out together with the drive chain
puller from the right-hand side.
7. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
4
5
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
8. Remove the wheel.
To install the rear wheel
1. Install the drive chain onto the rear
sprocket.
2. Lift the rear wheel off the ground,
and then install the drive chain
puller and the wheel by inserting
the wheel axle from the right-hand
side.
3. Install the drive chain puller, wash-
er and axle nut.
7-31
4. Lower the rear wheel so that it is
on the ground, and then put the
sidestand down.
5. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
6. Connect the brake torque rod to
the brake shoe plate by installing
the bolt and nut, and then tighten
the nut to the specified torque.
Tightening torque:
Brake torque rod nut:
26 Nm (2.6 m·kgf, 19 ft·lbf)
7. Insert a new cotter pin.
8. Adjust the drive chain slack. (See
EAU41654
page 7-20.)
9. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
60 Nm (6.0 m·kgf, 43 ft·lbf)
10. Adjust the brake pedal free play.
(See page 7-19.)