Table of Contents
Advertisement
30
www.aeg.com
Option
P1
P2
Press
or turn the knob for the
temperature to start the pyrolysis.
You can use the END function to delay
the start of the cleaning.
During the pyrolysis the oven lamp is off.
5. To change the default length of the
pyrolysis (P1 or P2), press
, and then press
6. When the oven is at the set
temperature, the door locks. The
display shows
heat indicator until the door unlocks.
7. When pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8. When the oven is cool again, the
door unlocks.
11.4 Cleaning reminder
To remind you that the pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the oven.
The cleaning reminder
goes out:
• after the end of the
• if you press
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
Description
Light clean-
ing. Duration:
1 h 30 min.
Normal clean-
ing. Duration:
3 h.
or
and the bars of the
pyrolysis.
and
the same time while PYR
flashes in the display.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
3. Close the door until it is at an angle
of approximately 45°.
to set
.
4. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
2
B
at
5. Pull the door trim to the front to
remove it.
6. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
A
45°
1
CAUTION!
Rough handling of the glass,
especially around the edges
of the front panel, can cause
the glass to break.
A
Advertisement
Table of Contents
