Samlexpower SEC-1223 Owner's Manual page 14

SECTION 5
MISE EN GARDE!
1. Avant de commencer, veuillez lire les instructions de sécurité a expliqué à la
section 1 intitulée "Instructions de sécurité importantes".
2. S'assurer que l'unité a été installée selon les directives données dans la sec-
tion 4 intitulée "Installation"
3. The unit has been factory preset for operation from nominal AC input voltage
of 120VAC, 50/60Hz. It the unit is to be operated from nominal AC voltage of
230 VAC, 50/60 Hz, please change internal input jumper setting, internal fuse
and AC power cord as per instruction given at Section 4 titled "Installation".
NOTE: Si l'appareil est utilisé à partir de 230 VCA sans faire les
5.2 SWITCHING ON PROCEDURE
a) Plug the supplied AC Power Cord to the AC Power Cord Inlet on the unit
(2, Fig 2.1)
b) Ensure that the power supply's On/Off Switch (1, Fig 2.1) is in off position
(edge of the switch with marking "o" will be in pressed down condition).
c) Switch off the 12V DC load that is required to be powered from the power supply.
d) Ensure that the ends of the Positive and Negative wires of the DC load to
be connected to the power supply have been properly terminated with Pin
Type Terminal Lugs as explained at Section 4.6.2.
e) Connect the Positive wire from the DC load to the Red Positive DC Input
Terminal (4, Fig 2.1) of the power supply and the Negative wire from the
DC load to the Black Negative DC Input Terminal (3, Fig 2.1) of the power
supply. Use 5/64" Hex Key provided with the unit to tighten the Hex Socket
Head set screws to ensure that the connections are secure and tight
f) Plug the AC Power Cord to the AC outlet. Ensure that AC power is available
in the outlet
g) Switch on the unit by pressing down on the edge of the switch marked
" – ". Neon light inside the switch will be lighted
h) 13.8 VDC will now be available at the DC output terminals (4, 3 in Fig 2.1)
i) Now switch on the DC load
5.3 SWITCHING OFF PROCEDURE
a) Switch off the DC load first
b) Switch off the power supply by pressing down on the edge of the switch
marked "o"
c) Unplug the AC power cord from the AC outlet
5.4 TROUBLESHOOTING
Refer to the Troubleshooting Guide at Section 7 in case of any abnormal operation.
14 | SAMLEX AMERICA INC.
| Operation
changements ci-dessus, la section d'entrée de l'appareil sera
endommagé et et la garantie sera annulée.