HP G62-373 Maintenance And Service Manual page 83

Remove the system board:
1. Disconnect the RJ-11 cable 1 from its mounting clip in the base enclosure.
2. Disconnect the optical drive connector cable 2 from the system board.
3. Disconnect the bluetooth cable 3 from the system board.
4. Disconnect the USB cable 4 from the system board.
5. Disconnect the power connector cable 5 from the system board.
6. Remove the three PM2.5×4.0 screws 1 that secure the system board to the base enclosure.
7. Grasp the right edge 2 of the system board.
8. Lift the system board 3, and pull it away from the base enclosure 4 at an angle.
Reverse this procedure to install the system board.
Maintenance and Service Guide
Removal and replacement procedures
4–39