Sanyo PLC-XT30 Owner's Manual page 70

Appendix
Some displays are not seen
during the operation.
PIN code dialog box appears
at start-up.
The Remote Control does
not work.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Specify the model number and explain about the problem. We will advise you
how to obtain service.
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Pixelworks ICs used.
70
– Check the Display function. See page 57.
– PIN code lock is being set. Enter a PIN code (the "1234" or numbers
you have set). See pages 25, 60–61.
– Check the batteries.
– Make sure no obstruction is between the projector and remote control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4' (5 m).
– Make sure that the remote control code conforms to the projector's
code. See page 57.
– Unlock the Key lock function for the remote control. See page 59.
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.