HP EliteBook 8440W Maintenance And Service Manual page 112

Computer Setup
Select
File menu (continued)
System Diagnostics (continued)
Restore Defaults
Reset BIOS security to factory default
Ignore Changes and Exit
Save Changes and Exit
Security menu
✎
Some of the menu items listed in this section may not be supported by your computer.
Select
Administrator Tools
Setup BIOS Administrator Password
User Management (requires a BIOS administrator password)
Create New BIOS User Account
Password Policy (requires a BIOS administrator password)
HP SpareKey
Always Prompt for HP SpareKey Enrollment
Fingerprint Reset on Reboot (If Present)
User Tools
Change Password
HP SpareKey Enrollment
Anti Theft
AT-P
DriveLock Passwords
5–16
To do this
■ Memory Test—Runs a comprehensive test on any memory
installed in the computer.
■ Battery Test—Runs a comprehensive test on any batteries
installed in the computer.
■ Error Log—Displays a log file if any errors have occurred.
Replace the configuration settings in Computer Setup with
the original factory settings. (Hard drive mode, password
settings, and security settings are not changed when you
restore the factory settings.)
Restore the BIOS security settings to the factory default.
Cancel any changes entered during the current session. Then
exit and restart the computer.
Save any changes entered during the current session. Then
exit and restart the computer. Your changes go into effect
when the computer restarts.
To do this
Set up a BIOS administrator password.
■ Select from a list of BIOS users.
■ Select from a list of ProtectTools users.
Revise password policy criteria.
Enable/disable HP SpareKey (enabled by default).
Enable/disable HP SpareKey enrollment (enabled by default).
Reset/clear the fingerprint reader ownership (select models
only; disabled by default).
Enter, change, or delete a BIOS administrator password.
Enroll or reset HP SpareKey, which is a set of security
questions and answers used if you forget your password.
Enable/disable Anti-Theft Protection.
■ Enable/disable DriveLock on any computer hard drive
(enabled by default).
■ Change a DriveLock user password or master password.
✎
DriveLock settings are accessible only when you enter
Computer Setup by turning on (not restarting) the
computer.
(Continued)
Maintenance and Service Guide