Table of Contents
Advertisement
1. Introduction, Features and Applications
Introduction
The M752 is a high performance microstepping driver based on pure-sinusoidal current control
technology. Owing to the above technology and the self-adjustment technology (self-adjust current
control parameters) according to different motors, the driven motors can run with smaller noise,
lower heating, smoother movement and have better performances at higher speed than most of the
drivers in the markets. It is suitable for driving 2-phase and 4-phase hybrid stepping motors.
Features
l High performance, cost-effective
l Supply voltage up to +75 VDC
l Output current up to 5.2A
l Self-adjustment technology
l Pure-sinusoidal current control technology
l Pulse input frequency up to 300 KHz
l TTL compatible and optically isolated input
Applications
Suitable for a wide range of stepping motors, from NEMA size 17 to 34. It can be used in various
kinds of machines, such as X-Y tables, labeling machines, laser cutters, engraving machines,
pick-place devices, and so on. Particularly adapt to the applications desired with low noise, low
heating, high speed and high precision.
2. Specifications
Electrical Specifications (T
= 25℃/77℉)
j
Parameters
Min
Output current
1.8
Supply voltage
+20
Logic signal current
7
Pulse input frequency
0
Isolation resistance
500
Tel: +086 0755-26434369
M752 Microstepping Driver Manual V1.0
l Automatic idle-current reduction
l 16 selectable resolutions in decimal and
binary, up to 51,200 steps/rev
l Suitable for 2-phase and 4-phase motors
l Support PUL/DIR and CW/CCW modes
l Short-voltage, over-voltage, over-current
protections
M752
Typical
Max
-
5.2 (3.7 RMS)
+48
+75
10
16
-
300
1
Web Site: www.leadshine.com
Operating Environment and other Specifications
Cooling
Operating Environment
Storage Temperature
Weight
Mechanical Specifications
Unit
A
Elimination of Heat
VDC
l
Driver's reliable working temperature should be <70 ℃ (158℉), and motor working temperature
mA
should be <80 ℃ (176℉);
kHz
l
It is recommended to use automatic idle-current mode, namely current automatically reduce to
MΩ
60% when motor stops, so as to reduce driver heating and motor heating;
Tel: +086 0755-26434369
M752 Microstepping Driver Manual V1.0
Natural Cooling or Forced cooling
Avoid dust, oil fog and corrosive gases
Environment
0 ℃ －50 ℃ (32℉－122℉)
Ambient Temperature
Humidity
Operating Temperature
Vibration
-20 ℃ －65 ℃ (-4℉－149℉)
Approx. 280g (10 oz)
(unit: mm
[inch])
Figure 1: Mechanical specifications
*Recommend use side mounting for better heat dissipation
2
40%RH－90%RH
70 ℃ (158℉) Max
2
5.9m/s
Max
Web Site: www.leadshine.com
Advertisement
Table of Contents
