Megapix DWC-MV421D User Manual page 38

WEBVIEWER*
S e t u p > N e t w o r k > N e t w o r k S e t t i n g s
U s e t h i s s e t u p p a g e t o a d j u s t t h e c a m e r a 's n e t w o r k s e t t i n g s .
IP Mode: Select the type of IP address for the camera.
•
- DHCP: Select this option if you have a DHCP Server and would like your camera to obtain its
network settings automatically.
- PPPoE: Select this option when you use WAN service. You will need a Username and Password
from your Internet Service Provider.
- Static IP: Manually enter the camera's network information.
IP Address: Enter the static IP Address of the camera
•
Subnet Mask: default is 255.255.255.0
•
Gateway: The gateway is your router's external (public) IP address. It is used when accessing the
•
camera from outside the network. The router will channel your data to the correct destination even
if it is on a different subnet mask.
DNS: Enter Primary DNS and
•
Secondary DNS. These translate web
addresses to IP addresses.
IPv6 Mode: If applicable, you can setup
•
the camera using the IPv6 protocol.
MAC Address: Displays the camera's
•
MAC (Mobile Access Control) Address.
Port: Displays all the ports necessary
•
for network communication.
Reboot your system to apply the
•
changes to your camera. When you
select Apply, a dialogue box will appear,
notifying you the camera will reboot to
apply the changes. It may take up to 20
seconds for the camera to reboot.
* Contact your Internet Service Provider or Network Administrator for more information.
All manuals and user guides at all-guides.com
3 8