Camera Module - HP Compaq Presario,Presario C770 Maintenance And Service Manual

Remove the microphone cable (3) from the display enclosure. The microphone receiver and cable
22.
are included in the Display Cable Kit, spare part number 454919-001.
Reverse this procedure to reassemble and install the display assembly.

Camera module

If it has been determined that the camera module is the component that must be replaced to complete the
computer repair, the display assembly does not have to be removed. Follow the procedures in this section
to replace the camera module. For information on replacing the display assembly and other display
assembly internal components, see
Description
Camera module
Before removing the camera module, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the camera module:
Turn the computer display-side up, with the front toward you.
1.
Open the computer as far as it will open.
2.
Remove the four rubber screw covers (1) on the display bezel top edge. The display rubber screw
3.
covers are included in the Display Rubber Kit, spare part number 454917-001.
60 Chapter 4 Removal and replacement procedures
Display assembly on page
Battery on page 40).
55.
Spare part number
462448-001