Electrical And Physical Data; Locating Unit; Corrosive Environment - Rheem 13 Series Installation Instructions Manual

2.4 ELECTRICAL & PHYSICAL DATA (SEE TABLE 1)
TABLE 1
ELECTRICAL AND PHYSICAL DATA – 13 SEER
Compressor
Model
Phase
Number
Rated Load
Frequency (Hz)
Amperes
Voltage (Volts)
(RLA)
Rev.1/10/2008
18 1-60-208-230 9/9
24 1-60-208-230 12.8/12.8
30 1-60-208-230 14.1/14.1
36 1-60-208-230 17/17
42 1-60-208-230 21.8/21.8
48 1-60-208-230 21.8/21.8
60 1-60-208-230 26.3/26.3
ELECTRICAL AND PHYSICAL DATA – 14 SEER
Compressor
Model
Phase
Number
Rated Load
Frequency (Hz)
Amperes
Voltage (Volts)
(RLA)
Rev.1/10/2008
18 1-60-208-230 9/9
24 1-60-208-230 12.8/12.8
30 1-60-208-230 14.1/14.1
36 1-60-208-230 17/17
42 1-60-208-230 17.9/17.9
48 1-60-208-230 21.8/21.8
60 1-60-208-230 26.4/26.4
NOTES:
Π20 Fins per inch [mm]
 Factory charged for 15 ft. [4.6 m] of line set
6
ELECTRICAL DATA
Fan Motor Minimum
Full Load Circuit
Locked Rotor
Amperes Ampacity
Amperes
(FLA) Amperes
(LRA)
48 0.6 12/12
58.3 0.6 17/17
73 0.8 19/19
96.7 1.2 23/23
112 1.2 29/29
117 1.2 29/29
134 1.2 35/35
ELECTRICAL DATA
Fan Motor Minimum
Full Load Circuit
Locked Rotor
Amperes Ampacity
Amperes
(FLA) Amperes
(LRA)
48 0.6 12/12
58.3 0.6 17/17
73 0.8 19/19
96.7 1.2 23/23
112 1.2 24/24
117 1.2 29/29
150 1.2 35/35

3.0 LOCATING UNIT

3.1 CORROSIVE ENVIRONMENT

The metal parts of this unit may be subject to rust or deterioration if exposed to a
corrosive environment. This oxidation could shorten the equipment's useful life.
Corrosive elements include, but are not limited to, salt spray, fog or mist in seacoast
areas, sulphur or chlorine from lawn watering systems, and various chemical conta-
minants from industries such as paper mills and petroleum refineries.
If the unit is to be installed in an area where contaminants are likely to be a prob-
lem, special attention should be given to the equipment location and exposure.
• Avoid having lawn sprinkler heads spray directly on the unit cabinet.
• In coastal areas, locate the unit on the side of the building away from the water-
front.
• Shielding provided by a fence or shrubs may give some protection, but cannot
violate minimum airflow and service access clearances.
• Elevating the unit off its slab or base enough to allow air circulation will help
avoid holding water against the basepan.
Regular maintenance will reduce the build-up of contaminants and help to protect
the unit's finish.
Fuse or HACR
Outdoor Coil
Circuit Breaker
Face Area
No.
Minimum Maximum Sq. Ft.
Rows
Amperes Amperes [m 2 ] Œ
15/15 20/20 11.06 [1.03]
20/20 25/25 11.06 [1.03]
25/25 30/30 13.72 [1.27]
30/30 35/35 16.39 [1.52]
35/35 50/50 21.85 [2.03]
35/35 50/50 21.85 [2.03]
45/45 60/60 21.85 [2.03]
Fuse or HACR
Outdoor Coil
Circuit Breaker
Face Area
No.
Minimum Maximum Sq. Ft.
Rows
Amperes Amperes [m 2 ] Œ
15/15 20/20 11.06 [1.03]
20/20 25/25 11.06 [1.03]
25/25 30/30 13.72 [1.27]
30/30 35/35 16.39 [1.52]
30/30 40/40 21.85 [2.03]
35/35 50/50 21.85 [2.03]
45/45 60/60 21.85 [2.03]
PHYSICAL DATA
Refrig.
Per
CFM Net
Circuit
[L/s] Lbs. [kg]
Oz. [g]
1 1700 [802] 91 [2580] 144 [65.3]
1 2370 [1118] 91 [2580] 130 [59]
1 2800 [1321] 101 [2863] 198 [89.8]
1 3575 [1687] 109 [3090] 215 [97.5]
1 3575 [1687] 150 [4252] 202 [91.6]
1 3575 [1687] 141 [3997] 205 [93]
1 3575 [1687] 228 [6464] 209 [94.8]
PHYSICAL DATA
Refrig.
Per
CFM Net
Circuit
[L/s] Lbs. [kg]
Oz. [g]
1 1700 [802] 91 [2580] 144 [65.3]
1 2370 [1118] 91 [2580] 130 [59]
1 2800 [1321] 101 [2863] 180 [81.6]
1 3575 [1687] 109 [3090] 215 [97.5]
1 3575 [1687] 150 [4252] 202 [91.6]
1 3575 [1687] 141 [3997] 205 [93]
2 3360 [1586] 259 [7343] 277 [125.6] 289 [131.1]
Weight
Shipping
Lbs. [kg]
152 [68.9]
138 [62.6]
208 [94.3]
227 [103]
214 [97.1]
217 [98.4]
221 [100.2]
Weight
Shipping
Lbs. [kg]
152 [68.9]
138 [62.6]
190 [86.2]
227 [103]
214 [97.1]
217 [98.4]