Supermicro SuperServer SYS-6029U-T Series User Manual page 172

SuperServer 6029U-T Series User's Manual
Ultra Riser Bracket
Screw to Chassis
Side (optional)
5
Screws for Default
Air Shrouds
Adding GPUs
1. Power down the system, unplug AC cords, and remove the top chassis cover.
2. Remove the appropriate riser card bracket, pictured above. On the rear of the chassis,
each bracket is secured by a small black plastic flip-lever with an arrow on it. Flip open
the appropriate lever to release the bracket, then pull the bracket out of the chassis.
For the Ultra riser (center) bracket, there is a thumbscrew to a standoff in the chassis
center.
3. Insert the GPU into the riser card slot while aligning the GPU rear L-shaped mounting
bracket. Add screws to secure the GPU L-shaped mounting bracket.
Left (WIO) Riser Bracket
2
2
Figure F-2. Riser Cards and GPU Positions
172
Screw to Chassis
2
Side (optional)
Positions for GPUs
Flip-levers
2