Supermicro SuperServer SYS-6029U-T Series User Manual page 178

SuperServer 6029U-T Series User's Manual
Notes for Installing in the Right-side Position (1)
•
Break off the necessary portions of the shroud to allow for cables.
•
Position the shroud as shown. The right side wall of the shroud should not cover the right-
most DIMM (P1-DIMMC1). The hole near the center of the shroud fits over the standoff in
the center of the chassis. The left wall of the shroud fits next to CPU2.
•
Routing the GPU power cables: Connect the cable to GPU_PWR1 on the motherboard
before placing the riser bracket and GPU into the chassis. Guide the cables to the left
between the GPU and the shroud.
Break off tabs if
necessary.
Route GPU power cable by
this edge of the shroud.
Figure F-9. Installing a GPU on the Right-side
Installing the Air Shroud for the
Right-side GPU (MCP-310-21905-0B)
Slot for
Shroud Tabs
178