Advertisement
Note:
The LAN connected computer must have an IP address in the same network
range (192.168.0.xxx) as the console server. If this is not convenient, you
can use the
online FAQ for details). The console server also has its DHCP client enabled
by default, so it will automatically accept any network IP address assigned by
any DHCP server on your network – and will then respond at both
192.168.0.1 and its DHCP address.
Select System: Administration, enter and confirm a new System Password
and click Apply
To assign your console server a static IP address or to permanently enable
DHCP, select System: IP then Network Interface and check DHCP or Static
for Configuration Method
The IMG4216-25 has an integrated VLAN switch that provides an Ethernet management
LAN (with firewall/router isolation and DHCP server). By default these ports are inactive.
ETHERNET port 24 can be configured as a broadband failover or OoB access port – to
activate, refer to the
selection, None.
Step 4
Select Serial & Network: Serial Port to display the labels, modes and
protocol options currently set for each serial port – by default all serial ports are
set in Console Server mode (refer the
To configure a serial port, click Edit
Configure the Common Settings (Baud Rate, Parity, Data Bits, Stop Bits and
Flow Control) to match those of the device being controlled
Select the Console Server protocols (Telnet, SSH, TCP and RFC2217) that are
to be used for the data connection to that port
IM4216-25 Quick Start (520002-Rev 3.2)
ARP Ping
command to set the IP address (refer
User Manual
– otherwise leave Failover Interface at its default
To activate the management LAN gateway:
Configure serial & network devices
Select System: IP then Management LAN
Interface and uncheck Disable
Enter the IP Address and Subnet Mask for
the Management LAN network segment,
leaving Gateway and DNS fields blank)
If you wish to use the DHCP server, refer to
the User Manual
User Manual
if other modes are required)
User Manual
or
Page 2
Advertisement
