Chevrolet UPLANDER 2007 Owner's Manual page 18

To recline the seatback, do the following:
1. Pull the nylon strap or lift the recline lever.
2. Press back on the seatback until it is in
the desired position
3. Let go of the strap or lever.
Removing the Bucket Seats
To remove the bucket seats, do the following:
1. Make sure the head restraint is in the
fully lowered position.
Notice: Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.
2. Fold the seatback flat on the seat, by either
pulling on the nylon strap, located on the rear
right hand side of the seat, or by lifting the
recline lever, located on the front right
hand side of the seatback.
18
3. Lift either one of the adjuster levers and slide
the seat to the most rearward position. See
"Adjusting the Bucket Seats Forward and
Rearward" earlier in this section.
4. Release the rear set of hooks from the floor
pins by pulling the nylon strap, located at the
base of the seat. Use the strap to guide
the seat forward.