Port Forwarding; Ddns Setup - HIKVISION DS-77 NI-SP Series Quick Start Manual

Units with older firmware have the RTSP PORT set to 554. A lot of cell phone carriers block
incoming data through port 554, which is why HikVision recommends changing that port to
10554
The HTTP PORT and the SERVER PORT can be changed if desired, in order to avoid
conflicts with the ISP or the existing network configuration.
After assigning the IP information to the DVR/NVR, connect a computer to the same router that
the DVR/NVR is connected to (wired connection is recommended, to avoid complications). Log
into the ROUTER, and proceed with PORT FORWARDING.
For PORT FORWARDING assistance contact the Internet Service Provider (ISP), or the router
manufacturer. Also refer to
Please be aware, that HikVision USA is not associated with www.portforward.com, and not
responsible for any activity between the user and www.portforward.com. Please refrain from
downloading any software from the abovementioned website.
Proceed to the "ROUTERS" section for step by step instructions.
DDNS registration has been made more user friendly, and takes only a few seconds to
complete. The legacy units require user registration on www.hik-online.com. This step is no
longer needed.
Click on the DDNS tab
In the DDNS tab:
a. Enable DDNS
b. Change the DDNS TYPE to HiDDNS (in some cases HkDDNS)
c. Make sure that the SERVER ADDRESS is set to
d. Create a DEVICE DOMAIN NAME (the domain name CANNOT contain spaces,
special characters and/or upper case letters

PORT FORWARDING

www.portforward.com

DDNS SETUP

Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
for port forwarding step by step instructions.
www.hik-online.com
www.hikvision.com/en/us