HIKVISION DS-77 NI-SP Series Quick Start Manual page 16

Working Mode, Select NIC and Default Route do not exist in the DS-7716NI-SP/16 Plug-n-
Play NVR
Working Mode sets the binding method between the 2 network cards.
Working Mode has 3 modes:
 Net Fault-tolerance (Both LAN ports need to be connected to the camera network. In
case one LAN port fails, the other one will take over the connection. This is a Network
Redundancy Mode)
 Load Balance (Both LAN ports need to be connected to the camera network. The LAN
cards split the network load. This is recommended for DS-9664NI-ST/RT)
 Multi-Address (In this mode the LAN cards operate independently from each other.
One LAN port will connect to the camera network, the other LAN will connect to the
Router for remote access).
Default Route determines which LAN port is used for accessing the DVR/NVR and not used
to connect to IP cameras
For DVRs/NVRs with 32 channels or less, set the Working Mode to MULTI-ADDRESS (For
this to take effect, please restart the DVR/NVR).
On the back of the DVR/NVR there are 2 LAN ports. The bottom port is LAN1, the top port is
LAN2
Connect LAN1 to the Router for remote access and connect LAN2 to the POE switch with the
cameras.
Step 1
Set the Default Route to LAN1.
Step 2
From the "SELECT NIC" dropdown select LAN1.
Step 3
Enable DHCP (check the checkbox). Press "APPLY" and then press "REFRESH"
Step 4
After pressing refresh, the IPv4 Address, IPv4 Subnet Mask and IPv4 Default Gateway will
have new values.
Step 5
Disable DHCP (uncheck the checkbox)
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
www.hikvision.com/en/us