Holding The Tool And Fitting It To The Reaction Arm - FIAM. eTensil E8C1A-1200 Use And Maintenance Manual

NB:
It should be noted that the first four functions are alternative, while the next six are inde-
pendent (independent = once enabled, these remain active together with the other en-
abled functions).
RESET: once you have entered the SMART-PRO menu, keep the lever pressed for at least
3 seconds.
* Some of the aforementioned starting methods may not be available for the whole range.
HOLDING THE TOOL AND FITTING IT
TO THE REACTION ARM
Fig. 1
Fig. 4
Do not clamp the tool at other points because this could damage it and
compromise its working operation; in such case Fiam cannot be held
responsible for any damage to the tool.
Fig. 2
Before starting work, hold the tool firmly as
shown in figure 1. For torques in excess of 4Nm
clamp the tool to a reaction arm; the body of the
tool can be clamped (figure 3) or the specific ring
can be used (figure 2 code 6920779180) the tool
can be clamped on its shell, the dedicated ring, or
at the top (fig. 4). The E8C...RE and E8C..90°/30°
models can be clampled on the shell only (fig. 3).
The tool should be clamped as shown in the figu-
res above.
Fig. 3
41