Operating Options - FIAM. eTensil E8C1A-1200 Use And Maintenance Manual

OPERATING OPTIONS

A long press (> 4 seconds) of the reverse button enters "Smart Pro" programming of
some functional parameters. Press the lever the number of times indicated beside the
desired function. Press the reverse button again to exit from programming mode.
Lever presses
Lever start (default)
1
Push-to-start (PTS)
2*
Lever start + Push-to-start
3*
"Latched lever" + push
4*
Lock in case of error,
5
ON/OFF (default OFF)
6
Enable untightening
7
8
9
UNTIGHTNEING
10
UNTIGHTENING
40
FUNCTION CONFIGURATIONS
Function
to start
Front light
(default ON)
(default ON)
SLOW START
PRE-AUTO
POST-AUTO
The tool turns for as long as pressure is kept on the lever
The tool turns keeping while pressure is kept on the PTS
The tool turns (Lever Start + Push-to-start) while si-
multaneously keeping pressure on the lever and on
the PTS; releasing the PTS will trigger an error)
The tool starts/stops when the lever is RELEASED and with the
Push-to-start maintained. (It is not necessary to keep pressure
on the lever; releasing the Push-to-start will trigger an error)
Function managed in the TPU M1 monitoring unit
Enables/disables the light over the work area while
the screwdriver is rotating. Resets the front flashing
light when 1,000,000 cycles have been reached
Enables/disables untightening
Screwdriver will gradually reach 100% of set speed
in 1,5 sec.
Of 4 turns (keep combination of start during all the
cycle, pause included).
Of 4 laps (keep combination of start during all the
cycle, pause included).
Description