Maintenance - Klutch 101670 Owner's Manual

Always wear protective gauntlets before changing saw blade!
Changing the Saw Blade
1. Remove the protective casing unscrewing the six screws.
2. Loosen the blade tension, turning the knob E in the anti-clockwise direction.
3. Extract the blade first from the guides and then from the cast iron pulleys.
4. Insert the new blade first between the guides and then into the cast iron pulleys, checking to
make sure the blade teeth are facing toward the work piece.
5. Turn the knob E to adjust the blade tension.
6. Replace the protective casing.
7. Reposition the blade guides in the correct position for next cut.
Maintain the product by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep all cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to
control. Keep handles dry, clean, and free from oil and grease. Also refer to the engine manufacturer's
instruction manual for additional information about engine maintenance. The following chart is based
on a normal operation schedule.

Maintenance

Interval
Every 3 months
Every 2 months
Maintenance
⚠WARNING
Maintenance Point
Check blade for dullness and replace if necessary.
Usually check the condition of the power supply cords and replace them if
they are broken, or even worse if the internal wires are shown.
Page 13 of 20