After Each Use; Maintenance; Parts Diagram - Klutch 49464 Owner's Manual

4 1/2in. x 6in. Metal Band Saw With Vertical Cutting Table
ADJUSTING THE BLADE TRACKING
This adjustment has been completed and tested at the factory. The need for adjusting should
rarely occur when the saw is used properly. If tracking becomes out of adjustment, use the
steps below to correct it:
1. Turn the blade tension knob (37) to loosen the blade a little while it still tracks against the
pulley.
2. Loosen the hex head screws (23 & 25).
3. Simultaneously turn with blade tension knob (37) and the hex head screw (24) to align the
blade with the edge of the pulley.
4. Tighten the hex head screw (24) to secure tracking then tighten the blade tension knob to
correct tension.
5. Adjust the blade guides according to the material size (see Blade Guide Adjustment).

After Each Use

After each use, clean the saw of debris and scraps of metal. If the saw will not be used for a
while, spread a thin coat of oil on the surfaces that not painted to prevent rust.
Store the saw when it is not in use. Store it in a dry, secure place out of the reach of children.
Inspect the saw for good working condition prior to storage and again before re-use.

Maintenance

WARNING:
• Put the switch in the locked or off position before making any adjustments, changing
accessories, or storing the tool to avoid the risk of starting the saw accidentally.
• Use only recommended parts for use with the saw. Parts that may be suitable for one tool
may create a risk of injury when used with another tool. Never use an accessory that has a
lower operating speed than the saw itself.
Maintain the saw. It is recommended that the general condition of any tool be examined before
it is used. Keep the saw in good repair by adopting a program of conscientious repair and
maintenance in accordance with the recommended procedures found in this manual.
Keep all cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
Keep handles dry, clean, and free from oil and grease.
OWNER'S MANUAL
10 of 16
4 1/2in. x 6in. Metal Band Saw With Vertical Cutting Table

Parts Diagram

OWNER'S MANUAL
11 of 16