Kathrein UFT 571 Operating Manual

Kathrein UFT 571 Operating Manual

Dvb-t-receiver
Hide thumbs Also See for UFT 571:

Advertisement

Quick Links

Operating Manual
DVB-T-Receiver
UFT 571 (silver/
black)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UFT 571 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kathrein UFT 571

  • Page 1 Operating Manual DVB-T-Receiver UFT 571 (silver/ black)
  • Page 2: Preface

    We wish you good reception and much pleasure using your new DVB-T receiver. Your KATHREIN Team If you should experience any unexpected problems with your UFT 571 (silver/black), please contact your specialist dealer or our hotline: KATHREIN-Werke KG ESC (Electronic Service Chiemgau)
  • Page 3: Table Of Contents

    Contents Preface Contents Safety Instructions and Important Information Controls, Displays and Connections Front View Rear View Remote Control Function Buttons Remote Control Command Set Connection and Setup Antenna Connection TV Connection Audio Connection Dolby Connection IR Receiver (Accessory) Inserting Batteries in the Remote Control Using the Front Panel/Display Using the Front Panel Display...
  • Page 4 Contents Timer Manual Timer Setting Automatic Timer Setting Deleting a Timer Event Scan Automatic Scan Channel Search Manual Scan Installation Time Offset Language/Character Set Signal Paths TV/VCR Scart Screen Format Digital Audio VCR Signals TV -> VCR VCR Signal VCR Record Active Antenna Antenna In Stand-by...
  • Page 5: Safety Instructions And Important Information

    Safety Instructions and Important Information This page contains important information about the operation, installation location and connection of the unit. Read these instructions carefully before setting up the unit. Mains cable Make sure that the mains power cable (power supply cable) is not damaged. Units with a damaged mains cable must be disconnected from the mains (disconnect mains connector) and repaired by a qualifi...
  • Page 6: Controls, Displays And Connections

    Controls, Displays and Connections This section provides a brief description of all the controls, displays and connections. Front View Rear View Front View Rear View Power switch (ON/OFF) Antenna input, RF signal Channel switching buttons Loop-through output, RF signal Volume adjustment buttons Audio outputs, 2 cinch sockets, L + R channel Electrical Digital data stream output (SPDIF = Sony Philips Digital Interchange...
  • Page 7: Remote Control Function Buttons

    Controls, Displays and Connections Remote Control Function Buttons The button symbols presented here can also be found in the description of the operating steps. Mute on/off OFF mode (Stand-by) Switching between TV and DVB-T mode, Channel Arrangement/Pool ON mode, channel number input, parental control Not used Audio mode,...
  • Page 8: Remote Control Command Set

    Switch to Address 1 = (for the fi rst receiver) Address 4 = (for the fourth receiver) (red) = Kathrein UFD 5XX code for remote control RC 400 Note: The RC 600 and RC 650 remote controls cannot be replaced!
  • Page 9: Connection And Setup

    BZD 30 from Kathrein). TV Connection Connect the UFT 571 (TV Scart socket) and the TV set by a Scart cable. If your TV has a stereo capability, you can receive the sound in stereo via the Scart connection.
  • Page 10: Inserting Batteries In The Remote Control

    Connection and Setup Inserting Batteries in the Remote Control Remove the cover on the rear of the remote control. Insert the two batteries supplied into the remote control, ensuring correct polarity - this is shown on the base of the battery compartment. Slide the cover back onto the housing until it locks in place.
  • Page 11: Using The Front Panel/Display

    Using the Front Panel/Display Using the Front Panel The unit has four operating buttons on its front panel (Channel ▲ and ▼ and Volume +/-) to change channels or alter the volume. By simultaneously pressing the “Channel ▲” and “Volume -” buttons the on-unit control can be temporarily switched to Radio/TV toggle mode.
  • Page 12: Initial Setup

    Initial Setup Important Information Before using the receiver for the fi rst time, make sure that it has been assembled, installed and connected properly, as described in the “Connection and Setup” section and in accordance with the safety instructions. Getting Started •...
  • Page 13 Initial Setup • Press the buttons to toggle country selections between Austria and Germany • Use the buttons to move the cursor onto the “Language” line and press the buttons to select the menu language you want to use • Use the buttons to move to the “Time zone”...
  • Page 14: Menu Structure

    Menu Structure Select the main menu by pressing the button. Move to the main menu submenus using the  arrow buttons ( ) and select one by pressing the button. You can quit the main menu and submenus at any time by pressing button.
  • Page 15: Channel Selection

    Channel Selection There are three possible ways to select a channel: • By direct input using the number pad & • By pressing the buttons and • By pressing the button twice to call up a list (see screenshot at left) sorted by channel number from which you can select the channel  you want using the arrow buttons (...
  • Page 16: Switching Between Tv And Radio

    Channel Selection Switching between TV and Radio Note: DVB-T does not yet currently broadcast radio stations. Press the button to toggle back and forth between TV and Radio mode. All functions available for TV (last channels, “zapper” function, Favourites lists, and channel lists) are also available separately for 999 radio stations.
  • Page 17: Managing Channels

    Managing Channels Main List Managing Channels in the Main List After running the automatic scan during fi rst installation the receivable channels are arranged in a preset sort order beginning with P001. You can change the sort order as you wish, and/or delete any channels you do not want.
  • Page 18: Marking For Parental Control

    Managing Channels Marking for Parental Control & Select the channel you want to bar using the buttons or directly on the number pad and mark it by pressing . Channels marked in this way are indicated by a “?” in front of the channel location in the main list. When parent control is active, you are prompted to enter the fi...
  • Page 19: Changing Favourites Names

    Managing Channels You can move and delete channels as in the main list using the " buttons (see “Managing Channels in the Main List”). Press the button to delete all channels from the Favourites list. The channels are only defi nitively deleted once you respond to the “Delete all channels?”...
  • Page 20: Epg - Electronic Programme Guide

    EPG - Electronic Programme Guide The EPG (Electronic Programme Guide) displays information on the current and upcoming programmes. The information provided is determined by the broadcasters, and differs widely from channel to channel. Many channels are broadcast with no usable ancillary information (SI data).

Table of Contents