Duration Period; Number Of Cycles; Starting Times - Graf one2clean Service Instructions Manual

The stored basic setups are retrieved one after the other using the
setup is confirmed with
2.2

Duration period

From the menu point "Basic setup" press the
Press button. The following appears on the screen e.g.:
By pressing the button the individual duration periods of the current configured basic setup are re-
trieved one after the other. The number can be increased (+1) starting with the last digit using the
arrow key. The number can be decreased (-1) starting with the last digit using the
In addition to the configured duration period of a cleaning cycle, the menu point "Duration period" contains
the sums of the actual duration periods (T17 to T19). Thus these duration periods add up the correspond-
ing duration periods and give the operator an overview of the selected settings (e.g. overview of the run
time of the compressor: T19).
2.3

Number of cycles

From the menu point "Duration period" press the
screen. Press button. The following appears on the screen:
The number of cycles per day can be increased (+1) starting with the last digit using the
The number can be decreased (-1) starting with the last digit using the
ber is stored using the
display.
2.4

Starting times

From the menu point "Number of cycles" press the
Press the button. The following appears on the screen:
2. Service level
one2clean 4EW C
, then the successful selection is confirmed with a 2-second display of "OK".
T1:
Cycles
button. The display then jumps from the menu back to the "Number of cycles"
Cycle1:
arrow key. "Duration period" appears on the screen.
X min
arrow key. "Number of cycles" appears on the
2
arrow key. "Starting times" appears on the screen.
HH:MM
3 / 8
arrow keys. The desired basic
arrow key.
arrow key.
arrow key. The selected num-