Service Menu Code; Service Level; Basic Setup Selection - Graf one2clean Service Instructions Manual

1. Service menu code

Control times can only be altered in the service menu. The code for this is

2. Service level

A range of queries can be run at service level, including the configuration of settings.
To reach the service level, select the menu point "Service menu" by pressing
level. Access the service menu by repeatedly pressing the
Pressing again brings up the prompt to enter the code.
The 4-digit code "2.0.1.3" can be entered using the arrow keys
this entry. The following appears:
The individual menu points and their meaning are displayed below:
Menu point
Basic setup
Duration period
Number of cycles
Starting times
Cycle restart
Clear logbook
Languages
2.1

Basic setup selection

After successful login, the menu point "Basic setup" appears on the screen. Access the selection of pro-
grammed basic setups by repeatedly pressing the
1. Service menu code
2013
service code
Code: _
Basic setup
Meaning
Pre-programmed basic setup with set cycle times
Cycle T1-12,
Cycle pause T13,14
Holiday mode T15,16
Maximum 24 cycles
Times for cycle start
e.g.: 07:00, 19:00
Program is restarted with current settings
"Operating hours meter" and "Old faults" are deleted
Various languages can be selected
button.
2 / 8
and
button. The following appears:
. Press the
at operator
button to confirm