When parking an excavator with rubber crawlers, ensure that the
seam (∞ ) is on top half way between the two sliders. See figure
in the "Checking the crawler tension" section (page 96).
Clean all parts of the running gear, paying particular atten-
tion to stones between the crawler and sprocket or idler.
Clean the area of the crawler tensioning cylinder.
Swivel the swivel frame 180° to the direction of travel as
shown in the figure.
Lower the dozer blade to the ground and raise the excava-
tor until the dozer blade touches the ground.
Lower the front attachments onto the ground and raise the
excavator about 200 mm off the ground.
Have a guide supervise the procedure.
Support the excavator with appropriate backing material, observing the vehicle weight.
Checking the crawler tension
The crawler seam (1) is half way between the idler and
sprocket.
Check the crawler sag as shown in the figure.
Crawler sag "A"
If the crawler sag is more than 15 mm, adjust the crawler.
If necessary, tighten or loosen the crawler.
Start the engine and rotate the lifted crawler briefly.
Caution: The area around the rotating crawler must be free of persons. Turn the starter switch to
the STOP position after turning and remove the key.
Recheck the crawler tension, readjusting it if necessary.
Perform the procedures on the second crawler.
96
10-15 mm
Maintenance