Table of Contents
Advertisement
Operation
Temperature Control
To adjust the interior temperature down, simply turn the
thermostat knob clockwise.
Condensate Disposal
For EF & FF Models:
The condensate drain is at the centre rear of the interior floor.
The condensate drain tube is connected to this drain and is
attached to the left front bottom of the unit behind the front sheet
metal. Unhook and place the drain tube into a suitable pan and
remove the drain plug. Turn the power to the unit to the off
position (O) and allow the unit to defrost.
For ER & FR Models:
Equipped with a drain pan that collects condensate during
manual defrost. This drain pan takes advantage of the
heat generated by the compressor to evaporate condensate
water, so there is no need to empty the pan during each
defrost cycle.
Material Compatibility
The interior cabinet of this unit is constructed of epoxy-coated
steel. Care must be exercised when determining which
chemicals may be stored in the refrigerator and freezer sections
and which type of storage materials should be employed.
ABS Plastic deteriorates when exposed to, but not limited
to, the following:
Aliphatic Hydrocarbons; Aromatic Hydrocarbons; Fully
and Partially Halogenated Hydrocarbons; Alcohols Monohydric;
Phenols; Ketones; Esters; Ethers; Organic
Acids (concentrates and dilute); and Concentrated
Oxidizing Acids. This information is taken from Plastics Edition 8
Thermoplastics and Thermosets published by
D.A.T.A. and The International Plastics Selector, Inc.
Cordura Companies
9889 Willow Creek Road P.O. Box 26637
San Diego, California 92126.
17
Advertisement
Table of Contents
