TENSION BAND ASSEMBLY REMOVAL
1) Remove the TENSION SPRING (2) from the MAINBASE (1).
2) Turn the DECK MECHANISM over.
3) After separating the tab of hook "A", remove the TENSION BAND ASSEMBLY (3).
NOTE
After assembling the TENSION BAND ASSEMBLY on the MAINBASE, adjust the position of the TENSION POLE
as shown in fig.30.
Avoid getting GREASE, OIL or foreign substances on the FELT of the BAND BRAKE.
Take care not to deform tab "A" when separating it.
Tension band assembly removal
Fig.28.
DATUM HOLE OF MAINBASE
DATUM HOLE OF
TENSION LEVER
Adjustment of the tension pole position
Fig.30.
17
Tension band assembly removal
Fig.29.