Supported Peripheral Devices Models - Citizen CT-D101 Series Programming Manual

1.5. Supported Peripheral Devices models

The models of peripheral devices applicable for control with this service are as follows.
For details on the functions of each model, refer to the instruction manual of each peripheral device.
Network I/F or Bluetooth I/F with USB host function is required for peripheral device control.
[Line Display]
Applicable Display
DSP01-LT
DSP02-LS
[Barcode Scanner]
Applicable Display
SCN01-Z1D
SCN02-Z2D
BC-NL3000U
Check that the scanner to be connected is set as follows. For the setting procedure, refer to the instruction
manual of the peripheral device to be used.
Interface
Keyboard
Terminator
About connection to printer
For the connection to the applicable peripheral device, first turn off the printer power and then connect to
a USB port of the corresponding interface shown in the figure below. Next, turn on the printer power, wait
about 30 seconds until the applicable peripheral device becomes ready to use so as to ensure stable
operation, and then execute the control start process of the peripheral device.
IF1-EFX2/IF1-WFx6
The following lists prohibited actions that must not be performed with regard to a peripheral device
connection.
I/F
USB
USB
I/F
USB
USB
USB
Item
USB HID Class
US Keyboard
Enter
CITIZEN UWP POS Print SDK - Programming Manual
Product Specification Overview
TFT line display
STN line display
Product Specification Overview
1D barcode scanner
2D barcode scanner
2D barcode scanner
Value
Communication protocol
Keyboard language
Data suffix
IF2-EFX2/IF2-WFx6
IF2-BT03/IF2-BT04
18
Description
IF2-WFx5