Perlick SIGNATURE Series Installation Manual page 10

PERLICK RESIDENTIAL INSTALLATION MANUAL
7). Remove the front panel from the door assembly by
removing the door gasket and then removing the overlay
mounting screws, 4 per side, from the perimeter of the
door assembly (Fig. 11). Rotate the front panel 180°. The
top becomes the bottom. Reattach using the same screws
and mounting holes and then reinstall the door gasket.
Front panel
Corner screws need not be
removed to remove front panel
Figure 11. Removing Front Panel
8). Remove the Perlick nameplate from the door front
using a plastic putty knife (Fig. 12). Install the new Perlick
nameplate included in the kit.
Nameplate
Figure 12. Nameplate
10 perlick.com
9). Insert the bearing into the door hinge bracket (Fig. 13).
10). Insert the V-block into the door bottom hinge bracket
and attach with the e-clip (Fig. 13). Note the orientation of
the V-block.
Bearing in
door top hinge
bracket
Door bottom bracket
Orientation
Figure 13. Bearing and V-Block
11). Attach the top and bottom hinges and push plunger
using screws removed in step 6 (Fig. 14).
Top hinge
and screws
Bottom hinge
and screws
Figure 14. Door Hinges
6°
V-block
BOTTOM VIEW