Toe Kick Installation - Perlick SIGNATURE Series Installation Manual

Measure front of opening
from floor surface to bottom
edge of countertop
Measure at both rear corners of
unit from floor surface to bottom
of countertop
Figure 4. Leveling the Unit
5). Check interior door openings to make sure the unit is
level and square. Install shelving and/or drawers. Place
the slide brackets squarely into the bracket grooves.
When installed properly, a "click" should be heard from the
slide bracket retaining tabs and the brackets should slide
smoothly. The retaining tabs will stop the shelf/drawer
when pulled out to full extension.
6). Turn on the power to the wall outlet at the circuit
breaker.
NOTE: Improper shelf/drawer installation may not actuate
slide mechanism.
PERLICK RESIDENTIAL INSTALLATION MANUAL
TOE PLATE INSTALLATION
Once the unit is secured in place, install the louvered toe
plate. Secure the plate by snapping the latch into the latch
catch on the unit (Figure 5).
The toe plate must be removed to
CAUTION
service the unit. The floor cannot
interfere with removal, and the louvered sections
must not be covered or obstructed. Obstructions could
prevent proper air circulation, which may damage the
unit.
NOTE: To achieve maximum performance, interior louver
openings and fan guard openings should never be obstructed.
Latch
Strike
Latch
Figure 5. Toe Plate Installation
perlick.com
7