Power-Section; Installation - Omnitronic PAM-500 User Manual

10-BAND GRAPHIC EQUALIZER
Used to fine-tune the master output. The frequencies are as follows: 31 Hz, 63 Hz, 125 Hz, 250 Hz, 500 Hz,
1 kHz, 2 kHz, 4 kHz, 8 kHz and 16 kHz. They can be adjusted by ±12 dB.

4.8 Power-section

DC IN SOCKET
Used to plug the power unit in.
Occupation DC-connection:
POWER SWITCH
Press this button to start operation.
AC INPUT SOCKET
Used to plug the power cord in.
FUSEHOLDER
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same rating and
power.
AC VOLTAGE-SELECTOR
Make sure that the selector is properly set.

5. INSTALLATION

Roll the PA-system to the desired installation area.
Open the PAM-500 by carefully lifting the safety latch. Lift the speaker-systems.
This PA-system must only be installed at a solid, plane, anti-slip, vibration-free, oscilation-free and fire-
resistant location.
Before installing the system, make sure that the installation area can hold a minimum point load of 5 times
the system's load (e.g. weight 20 kg - point load 100 kg).
This PA-system must never be installed higher than 100 cm.
Make sure that the power switch is set to "OFF". Before you connect the devices, all units have to be
switched off and alll level-controls are set to "0".
Open the accessory compartment at the power tower's rear and take out the included accessory:
2 XLR-XLR microphone cables
31/35 11038890_V_1_0.DOC