Power Feed - Grizzly WOOD MILL G9959 Instruction Manual

Power Feed (G9977)
Figure 17. Power feed components.
The following is a list of components for the
power feed on the Model G9977 Wood Mill. Refer
to Figure 17, above while reading the descrip-
tions below.
1. Stop Switch – Causes the power feed to
stop when either button is depressed by
the plunger stop.
2. Plunger Stop – Can be positioned along
the table edge and depresses Stop Switch
button.
3. Rapid Traverse Button – Once the direc-
tion lever has been activated, pushing this
button will cause the power feed to move
the table at full speed.
4. Direction Lever – Tilting this lever to the
left causes the table to travel to the left.
Tilted to the right, this lever causes the
table to travel to the right.
5. Speed Dial – Controls the speed that the
table moves. Turning the dial clockwise
causes the table to move faster.
6. On/Off Switch – This is the master switch
for the power feed unit.
G9959/G9977 Wood Mill
A power feed is supplied and installed on the
Model G9977, only. The power feed allows
motorized speed control over the table along the
longitudinal axis.
To operate the power feed:
1. Loosen the table locking levers located just
below the front edge of the table.
2. Adjust the plunger stops on the front edge
of the table to the desired distance you
wish the table to travel. (When they hit the
stop switch the power feed will be deacti-
vated.)
Before running your power feed be sure
there is enough running clearance between
the table, spindle, vise, clamps and/or
parts. Be aware that all of these can
become pinch points.
3. Use the On/Off switch located below and to
the right of the power feed lever to turn on
the power feed.
4. Push the lever to the right to move the
table to the right.
5. Push the lever to the left to move the table
to the left.
6. Turn the dial at the base of the lever to
increase or decrease the speed of the table
movement.
-23-