Table Insert; Spindle Height - Grizzly G8693 Instruction Manual

Table Insert

The Table Insert (REF 16) should be used at all
times to provide support for the workpiece.
When the cutter or bit is completely above the
table surface, the Table Insert should be used with
3
the smaller (1 ⁄ '') hole facing up. See Figure 9.
8
Figure 9. Guard Removed For Clarity.
When the cutter or router bit is below the surface
of the table, the Table Insert should be used with
5
the 2- ⁄ '' opening facing up. See Figure 10.
8
Always make sure the cutter will not hit the Insert
before turning on the Mini Shaper.
Figure 10. Guard Removed For Clarity.
-16-
Insert Removed
Insert Installed

Spindle Height

The Spindle has a maximum vertical adjustment
3
of ⁄ ''. The large knob on the rear of the Shaper/
4
Router is used to set the height. Loosen the knob
by turning it counterclockwise. The Spindle
assembly can now be raised or lowered by mov-
ing the knob right or left in the inclined slot. When
the desired height is obtained, turn the knob
clockwise to lock it in place. See Figure 11.
Spindle cutters can be raised by using the collar
(REF 59) provided.
Figure 11. Spindle height locking knobs.
G8693 Mini Shaper