Bracelet Designs
You can make a your own bracelet by sewing the bracelet
designs on a water soluble stabilizer.
Use the same thread for the bobbin as the needle thread.
Use a fully wound bobbin.
Set the low bobbin thread warning level to 3 or 4 (refer to
page 51).
Set the maximum sewing speed to 600 spm or less (refer
to page 51).
Set the water soluble stabilizer in the hoop.
Be sure that the stabilizer is stretched tightly in the hoop.
Select the desired bracelet design pattern and sew.
Remove the water soluble stabilizer from the hoop.
Trim away the water soluble stabilizer surrounding the
design pattern with scissors.
Remove the water soluble stabilizer by soaking the
bracelet design into the bowl of warm water.
Attach the chain rings* to the each end of the bracelet.
q Chain ring
q
q
* Chain rings are not included with the machine.
47